Feeder Armor Point I/O Faulted

Possible Causes:
1) Cable disconnected or damaged
2) Noise on signal line
3) Device Fault or failure

Possible Solutions:
1) Reconnect disconnected cable
2) Replace faulty cable
3) Cycle power on I/O communications module
4) Replace faulty I/O communications module
5) If multiple Node faults exist, Cycle power for PLC CPU Rack
6) If multiple Node faults exist, PLC Rack Ethernet module may be damaged or required configuration.
7) If multiple Node faults exist, ethernet switch may be disconnected or damaged.